Line Coverage for Module :
prim_mubi4_sync
| Line No. | Total | Covered | Percent |
TOTAL | | 6 | 6 | 100.00 |
CONT_ASSIGN | 96 | 1 | 1 | 100.00 |
CONT_ASSIGN | 96 | 1 | 1 | 100.00 |
CONT_ASSIGN | 96 | 1 | 1 | 100.00 |
CONT_ASSIGN | 96 | 1 | 1 | 100.00 |
ALWAYS | 117 | 1 | 1 | 100.00 |
CONT_ASSIGN | 168 | 1 | 1 | 100.00 |
95 // hence this mux can be implemented behaviorally.
96 4/4 assign mubi[k] = (|sig_unstable_buf) ? reset_value[k] : mubi_q[k];
Tests: T1 T2 T3 | T1 T2 T3 | T1 T2 T3 | T1 T2 T3
97 end
98
99 // Note regarding SVAs below:
100 //
101 // 1) Without the sampled rst_ni pre-condition, this may cause false assertion failures right after
102 // a reset release, since the "disable iff" condition with the rst_ni is sampled in the "observed"
103 // SV scheduler region after all assignments have been evaluated (see also LRM section 16.12, page
104 // 423). This is a simulation artifact due to reset synchronization in RTL, which releases rst_ni
105 // on the active clock edge. This causes the assertion to evaluate although the reset was actually
106 // 0 when entering this simulation cycle.
107 //
108 // 2) Similarly to 1) there can be sampling mismatches of the lc_en_i signal since that signal may
109 // originate from a different clock domain. I.e., in cases where the lc_en_i signal changes exactly
110 // at the same time that the clk_i signal rises, the SVA will not pick up that change in that clock
111 // cycle, whereas RTL will because SVAs sample values in the "preponed" region. To that end we make
112 // use of an RTL helper variable to sample the lc_en_i signal, hence ensuring that there are no
113 // sampling mismatches.
114 `ifdef INC_ASSERT
115 mubi4_t mubi_in_sva_q;
116 always_ff @(posedge clk_i) begin
117 1/1 mubi_in_sva_q <= mubi_i;
Tests: T1 T2 T3
118 end
119 `ASSERT(OutputIfUnstable_A, sig_unstable |-> mubi_o == {NumCopies{reset_value}})
120 `ASSERT(OutputDelay_A,
121 rst_ni |-> ##[3:4] sig_unstable || mubi_o == {NumCopies{$past(mubi_in_sva_q, 2)}})
122 `endif
123 end else begin : gen_no_stable_chks
124 assign mubi = mubi_sync;
125 `ifdef INC_ASSERT
126 mubi4_t mubi_in_sva_q;
127 always_ff @(posedge clk_i) begin
128 mubi_in_sva_q <= mubi_i;
129 end
130 `ASSERT(OutputDelay_A,
131 rst_ni |-> ##3 (mubi_o == {NumCopies{$past(mubi_in_sva_q, 2)}} ||
132 $past(mubi_in_sva_q, 2) != $past(mubi_in_sva_q, 1)))
133 `endif
134 end
135 end else begin : gen_no_flops
136
137 //VCS coverage off
138 // pragma coverage off
139
140 // This unused companion logic helps remove lint errors
141 // for modules where clock and reset are used for assertions only
142 // This logic will be removed for synthesis since it is unloaded.
143 mubi4_t unused_logic;
144 always_ff @(posedge clk_i or negedge rst_ni) begin
145 if (!rst_ni) begin
146 unused_logic <= MuBi4False;
147 end else begin
148 unused_logic <= mubi_i;
149 end
150 end
151
152 //VCS coverage on
153 // pragma coverage on
154
155 assign mubi = MuBi4Width'(mubi_i);
156
157 `ASSERT(OutputDelay_A, mubi_o == {NumCopies{mubi_i}})
158 end
159
160 for (genvar j = 0; j < NumCopies; j++) begin : gen_buffs
161 logic [MuBi4Width-1:0] mubi_out;
162 for (genvar k = 0; k < MuBi4Width; k++) begin : gen_bits
163 prim_buf u_prim_buf (
164 .in_i(mubi[k]),
165 .out_o(mubi_out[k])
166 );
167 end
168 1/1 assign mubi_o[j] = mubi4_t'(mubi_out);
Tests: T1 T2 T3
Cond Coverage for Module :
prim_mubi4_sync
| Total | Covered | Percent |
Conditions | 8 | 8 | 100.00 |
Logical | 8 | 8 | 100.00 |
Non-Logical | 0 | 0 | |
Event | 0 | 0 | |
LINE 96
EXPRESSION (((|gen_flops.gen_stable_chks.gen_bufs_muxes[0].sig_unstable_buf)) ? gen_flops.gen_stable_chks.reset_value[0] : gen_flops.gen_stable_chks.mubi_q[0])
--------------------------------1--------------------------------
-1- | Status | Tests |
0 | Covered | T1,T2,T3 |
1 | Covered | T1,T2,T3 |
LINE 96
EXPRESSION (((|gen_flops.gen_stable_chks.gen_bufs_muxes[1].sig_unstable_buf)) ? gen_flops.gen_stable_chks.reset_value[1] : gen_flops.gen_stable_chks.mubi_q[1])
--------------------------------1--------------------------------
-1- | Status | Tests |
0 | Covered | T1,T2,T3 |
1 | Covered | T1,T2,T3 |
LINE 96
EXPRESSION (((|gen_flops.gen_stable_chks.gen_bufs_muxes[2].sig_unstable_buf)) ? gen_flops.gen_stable_chks.reset_value[2] : gen_flops.gen_stable_chks.mubi_q[2])
--------------------------------1--------------------------------
-1- | Status | Tests |
0 | Covered | T1,T2,T3 |
1 | Covered | T1,T2,T3 |
LINE 96
EXPRESSION (((|gen_flops.gen_stable_chks.gen_bufs_muxes[3].sig_unstable_buf)) ? gen_flops.gen_stable_chks.reset_value[3] : gen_flops.gen_stable_chks.mubi_q[3])
--------------------------------1--------------------------------
-1- | Status | Tests |
0 | Covered | T1,T2,T3 |
1 | Covered | T1,T2,T3 |
Branch Coverage for Module :
prim_mubi4_sync
| Line No. | Total | Covered | Percent |
Branches |
|
8 |
8 |
100.00 |
TERNARY |
96 |
2 |
2 |
100.00 |
TERNARY |
96 |
2 |
2 |
100.00 |
TERNARY |
96 |
2 |
2 |
100.00 |
TERNARY |
96 |
2 |
2 |
100.00 |
96 assign mubi[k] = (|sig_unstable_buf) ? reset_value[k] : mubi_q[k];
-1-
==>
==>
Branches:
-1- | Status | Tests |
1 |
Covered |
T1,T2,T3 |
0 |
Covered |
T1,T2,T3 |
96 assign mubi[k] = (|sig_unstable_buf) ? reset_value[k] : mubi_q[k];
Warning: the following expressions can not be annotated
-1- ((|gen_flops.gen_stable_chks.gen_bufs_muxes[1].sig_unstable_buf)) ? ...;
Branches:
-1- | Status | Tests |
1 |
Covered |
T1,T2,T3 |
0 |
Covered |
T1,T2,T3 |
96 assign mubi[k] = (|sig_unstable_buf) ? reset_value[k] : mubi_q[k];
Warning: the following expressions can not be annotated
-1- ((|gen_flops.gen_stable_chks.gen_bufs_muxes[2].sig_unstable_buf)) ? ...;
Branches:
-1- | Status | Tests |
1 |
Covered |
T1,T2,T3 |
0 |
Covered |
T1,T2,T3 |
96 assign mubi[k] = (|sig_unstable_buf) ? reset_value[k] : mubi_q[k];
Warning: the following expressions can not be annotated
-1- ((|gen_flops.gen_stable_chks.gen_bufs_muxes[3].sig_unstable_buf)) ? ...;
Branches:
-1- | Status | Tests |
1 |
Covered |
T1,T2,T3 |
0 |
Covered |
T1,T2,T3 |
Assert Coverage for Module :
prim_mubi4_sync
Assertion Details
NumCopiesMustBeGreaterZero_A
Name | Attempts | Real Successes | Failures | Incomplete |
Total |
952 |
952 |
0 |
0 |
T1 |
1 |
1 |
0 |
0 |
T2 |
1 |
1 |
0 |
0 |
T3 |
1 |
1 |
0 |
0 |
T4 |
1 |
1 |
0 |
0 |
T5 |
1 |
1 |
0 |
0 |
T6 |
1 |
1 |
0 |
0 |
T7 |
1 |
1 |
0 |
0 |
T8 |
1 |
1 |
0 |
0 |
T9 |
1 |
1 |
0 |
0 |
T10 |
1 |
1 |
0 |
0 |
OutputsKnown_A
Name | Attempts | Real Successes | Failures | Incomplete |
Total |
12476496 |
12086800 |
0 |
0 |
T1 |
2312 |
2253 |
0 |
0 |
T2 |
1957 |
1859 |
0 |
0 |
T3 |
2797 |
2676 |
0 |
0 |
T4 |
7445 |
7392 |
0 |
0 |
T5 |
4379 |
4291 |
0 |
0 |
T6 |
3174 |
3102 |
0 |
0 |
T7 |
5045 |
4979 |
0 |
0 |
T8 |
2896 |
2516 |
0 |
0 |
T9 |
2335 |
2145 |
0 |
0 |
T10 |
4544 |
4447 |
0 |
0 |
gen_flops.gen_stable_chks.OutputDelay_A
Name | Attempts | Real Successes | Failures | Incomplete |
Total |
12476496 |
12071074 |
0 |
2556 |
T1 |
2312 |
2250 |
0 |
3 |
T2 |
1957 |
1856 |
0 |
3 |
T3 |
2797 |
2670 |
0 |
3 |
T4 |
7445 |
7389 |
0 |
3 |
T5 |
4379 |
4288 |
0 |
3 |
T6 |
3174 |
3099 |
0 |
3 |
T7 |
5045 |
4976 |
0 |
3 |
T8 |
2896 |
2501 |
0 |
3 |
T9 |
2335 |
2139 |
0 |
3 |
T10 |
4544 |
4444 |
0 |
3 |
gen_flops.gen_stable_chks.OutputIfUnstable_A
Name | Attempts | Real Successes | Failures | Incomplete |
Total |
12476496 |
21898 |
0 |
0 |
T1 |
2312 |
1 |
0 |
0 |
T2 |
1957 |
1 |
0 |
0 |
T3 |
2797 |
29 |
0 |
0 |
T4 |
7445 |
1 |
0 |
0 |
T5 |
4379 |
1 |
0 |
0 |
T6 |
3174 |
1 |
0 |
0 |
T7 |
5045 |
1 |
0 |
0 |
T8 |
2896 |
5 |
0 |
0 |
T9 |
2335 |
2 |
0 |
0 |
T10 |
4544 |
1 |
0 |
0 |